http://www.purl.org/tcl/home/man/tcl8.4/TclCmd/tell.htm ---- '''tell and flush''' If you are using tell and you do reads and writes in between your calls to tell, you usually will have to do a flush or your tell will fail with a -1 return value. This is because the Tcl Channel code cannot ensure an accurate 'tell' value until you flush out pending i/o on your open channel. -mikeH Clif was nice enough to type an example of this behaviour in the Tcl'ers chat. it's included below: % set f [open tst.dat w+] file4 % tell $f 0 % puts $f "a" % tell $f 2 % seek $f 0 % read $f 1 a % tell $f 1 % puts $f bb % tell $f -1 ---- '''tell and open using "a", "a+", APPEND , etc..''' If you are using tell in combination with a channel opened via APPEND (et. al), keep in mind that for each write performed, your file position is going to be placed at the end of the file. Tcl Channels are reflecting C library behaviour in this respect (which it should do if you think about it). -mikeH ''need some examples of this behaviour here...'' ---- [Tcl syntax help] - [Arts and crafts of Tcl-Tk programming] - [Category Command]