Aliases are a powerful concept of the '''[interp]''' command, but they lack the direct introspection possibilities that are available for procs. Some interesting of the info subcommands only work on procedures, not on aliases.
Some introspection commands exist, namely the [interp] subcommands ''alias'', ''target'' and ''aliases''. It should however be noted that these operate on ''alias tokens'', which are not necessarily the same as the command-name of the alias, but a unique identifier that was returned when the alias was created. It is ''usually'' the same as the command-name specified for the alias, but even that is not guaranteed (a number of colons may have been prepended to that name), and the alias can subsequently have been renamed, so [interp alias] cannot reliably be used to look up the definition of a command, even if that is known to be an alias.
One can however use an execution [trace] on an alias command to determine what that command maps to:======
proc which_alias {cmd} {
uplevel 1 [list ::trace add execution $cmd enterstep ::error]
catch {uplevel 1 $cmd} res
uplevel 1 [list ::trace remove execution $cmd enterstep ::error]
return $res
}======
----
Below some procs to inspect aliases simliar to '''[info] args''', a similar proc for '''info body''' can be built easily (just use the alias following outlined below and apply '''info body''' to the actual target of the alias).
'''Note:''' ''Since this procedure was written with the (incorrect) assumption that the [interp] subcommands will accept any variant of a command name as alias token, it doesn't always work.''
======
# [info args] like proc following an alias recursivly until it reaches
# the proc it originates from or cannot determine it.
# accounts for default parameters set by interp alias
#
proc aliasargs {cmd} { set orig $cmd
set defaultargs [list]
# loop until error or return occurs
while {1} {
# is it a proc already?
if {[string equal [info procs $cmd] $cmd]} {
set result [info args $cmd]
# strip off the interp set default args
return [lrange $result [llength $defaultargs] end]
}
# is it a built in or extension command we can get no args for?
if {![string equal [info commands $cmd] $cmd]} {
error "\"$orig\" isn't a procedure"
}
# catch bogus cmd names
if {[lsearch [interp aliases {}] $cmd]==-1} {
error "\"$orig\" isn't a procedure or alias or command"
}
if {[llength [set cmdargs [interp alias {} $cmd]]]>0} {
# check if it is aliased in from another interpreter
if {[catch {interp target {} $cmd} msg]} {
error "Cannot resolve \"$orig\", alias leads to another interpreter."
}
if {$msg != {} } {
error "Not recursing into slave interpreter \"$msg\".\
\"$orig\" could not be resolved."
}
# check if defaults are set for the alias
if {[llength $cmdargs]>1} {
set cmd [lindex $cmdargs 0]
set defaultargs [concat [lrange $cmdargs 1 end] $defaultargs]
} else {
set cmd $cmdargs
}
}
}
}======
----
As it was discussed in the tcl'ers chatroom there are some complex situations that can arise with alias introspection, especially with cross interp aliases.
* [info level], especially with a negative level, may not work as expected
* [uplevel] and [upvar] may do unexpected things
Basically those commands do totally reasonable things, but if a ''call sequence'', this means the list of commands executed, crosses interp boundaries the reasonable may not be the obvious. The main difficulty is the inequality between ''call sequence'' and ''stack level'' if interp boundaries are crossed. The ''stack level'' is an interp local concept, while the ''call sequence'' can cross interpreters. The above mentioned commands operate on the ''stack level'', not on the ''call sequence''.
----
[C<<categoryies>> Introspection]